Point-to-Point Protocol
Left running head:
Chapter name (automatic)
344
Beta Beta
OmniAccess 5740 Unified Services Gateway CLI Configuration Guide
Alcatel-Lucent
T
O SET THE AUTHENTICATION PASSWORD
EXAMPLE
ALU(config-if Serial0/0:0)# ppp authentication password pass1
ALU(config-if Serial0/0:0)# no ppp authentication password
Note: Server side credentials (user name and password) are mandatory for CHAP/PAP/EAP
authentication protocol.
T
O SET THE AUTHENTICATION CLIENT USER NAME
EXAMPLE
ALU(config-if Serial0/0:0)# ppp authentication client-username
client1
ALU(config-if Serial0/0:0)# no ppp authentication client-
username
Command (in ICM) Description
ppp authentication password
<password>
This command enables you to set a
password for PPP authentication on the
server side.
no ppp authentication password The “no” command deletes the
configured PPP authentication password
on the server side.
Command (in ICM) Description
ppp authentication client-
username <username>
This command is used to set user name
for PPP authentication on the client side.
no ppp authentication client-
username
The “no” command deletes the
configured authentication user name on
the client side.