Alcatel-Lucent OmniAccess 5740 - Page 385

PPPoE Configuration
Except on the first page, right running head:
Heading1 or Heading1NewPage text (automatic)
359
Alcatel-Lucent
Beta Beta
OmniAccess 5740 Unified Services Gateway CLI Configuration Guide
Step 5: Configure PPPoE Optional Parameters. See “PPPoE Optional
Parameters”
• Configure service name for PPPoE. See “To Configure PPPoE Service
Name”.
• Configure the access concentrator name of the PPPoE server. See “To
Configure PPPoE Service Name”.
• Initiate PPPoE negotiation. See “To Initiate PPPoE Negotiation Manually”
• Configure PPPoE retry timer. See “To Set Timer for Retransmission of
PADI/PADR Packets”
• Configure PPPoE maximum retry timer. See “To Set Maximum Retry for
PADIs”
Note: Configuration of LCP parameters, IPCP parameters, timers and counters, and
authentication, are optional and these commands are similar to the commands that
are documented in the PPP chapter. The show commands are also similar to the PPP
show commands.
For more details on these commands, refer to the “Point-to-Point Protocol” chapter.