MLFR Configuration
Except on the first page, right running head:
Heading1 or Heading1NewPage text (automatic)
387
Alcatel-Lucent
Beta Beta
OmniAccess 5740 Unified Services Gateway CLI Configuration Guide
Step 14: Administratively bring up the interface
ALU(config-if <interface-name>)# no shutdown
Example:
ALU(config-if Serial0/0:0)# no shutdown
Step 15: Set encapsulation to MLFR. See “To Set MLFR Encapsulation on an
Interface”
Step 16: Configure MLFR Optional Parameters.
• Assign Link Identification (LID) to the interface. See “To Assign Link
Identification (LID) to the Interface”
• Configure the Hello interval. See “To Configure Hello Interval”
• Configure the Acknowledge interval. See “To Configure the Acknowledge
Interval”
• Configure the retry count. See “To Configure the Retry Count”
Step 17: Use the show commands to view the MLFR configuration. See “MLFR
Show Commands”
To Next Page
Loading...
