Alcatel-Lucent OmniAccess 5740 - Page 427

OAM Configuration on OmniAccess 5740 USG
Except on the first page, right running head:
Heading1 or Heading1NewPage text (automatic)
401
Alcatel-Lucent
Beta Beta
OmniAccess 5740 Unified Services Gateway CLI Configuration Guide
Step 11: Enable a continuity check protocol on a MEP. See “To Enable/Disable
CCM (Continuity Check Message) on MEP”
Step 12: Configure MEP optional parameters. See “Configure MEP Optional
Parameters”
• Configure MAC address for a MEP. See “To Configure MAC Address for a
MEP”
• Configure lowest priority fault alarm for a MEP. See “To Configure Lowest
Priority Fault Alarm”
• Configure time interval for the fault alarm. See “To Configure Time Interval
for Fault Alarm”
• Configure reset time for the fault alarm. See “To Reset Time Interval for
Fault Alarm”
• Enable/disable alarm indication signal transmission (AIS) on a MEP. See
“To Enable/Disable AIS on a MEP”
• Configure time interval for AIS transmission. See “To Configure AIS
Transmission Period”
Step 13: Initiate Ethernet OAM performance management tests. See “Initiate
Ethernet OAM Performance Management Tests” (Optional)
• Enable Ethernet test signal on a MEP. See “To Enable/Disable Ethernet
Test Signal on a MEP”
9 Configure test pattern for Ethernet test signal on a MEP. See “To
Configure Test Pattern for Ethernet Test Signal”
9 Initiate Ethernet test signal on a MEP. See “To Initiate Ethernet Test
Signalling”
9 Initiate Ethernet CFM one-way delay test on a MEP. See “To Initiate
Ethernet CFM One-way Delay Test”
9 Initiate Ethernet CFM two-way delay test on a MEP. See “To Initiate
Ethernet CFM Two-way Delay Test”