Alcatel-Lucent OmniAccess 5740 - Page 485

LFI Configuration on FR
Except on the first page, right running head:
Heading1 or Heading1NewPage text (automatic)
459
Alcatel-Lucent
Beta Beta
OmniAccess 5740 Unified Services Gateway CLI Configuration Guide
Step 11: Configure Data-link Connection Identifier (DLCI) on the interface.
ALU(config-if <interface-name>)# frame-relay
interface-dlci <16-1007>
Example:
ALU(config)#interface Serial0/0:0
ALU(config-if Serial0/0:0)# frame-relay interface-dlci
100
Step 12: Configure fragment size on the Serial interface. See “To Configure
Fragment Size on an Interface”
Step 13: Configure slippage MRU on the Serial interface. See “To Configure
Slippage MRU (Maximum Receive Unit) on an Interface” (Optional)
Step 14: Configure QoS out policy on the interface. See “To Attach a Policy Map
to the Interface”
For more information on configuring policy map, refer to “Quality of
Service” chapter.
Step 15: Use “LFI - FR Show Commands” to view the LFI-FR configuration.