Alcatel-Lucent OmniAccess 5740 - Page 488

Link Fragmentation and Interleaving (LFI)
Left running head:
Chapter name (automatic)
462
Beta Beta
OmniAccess 5740 Unified Services Gateway CLI Configuration Guide
Alcatel-Lucent
T
O CONFIGURE SLIPPAGE MRU (MAXIMUM RECEIVE UNIT) ON AN INTERFACE
EXAMPLE
ALU(config-if Serial 0/0:0)# slippage mru 16
ALU(config-if Serial 0/0:0)# no slippage mru
T
O ATTACH A POLICY MAP TO THE INTERFACE
EXAMPLE
ALU(config-if Serial 0/0:0)# service-policy out P1
ALU(config-if Serial 0/0:0)# no service-policy out P1
Command (in ICM) Description
slippage mru <16-128> This command is entered in the Interface
Configuration mode.
This command specifies the number of
fragments that can be buffered per Virtual
Circuit.
The default slippage MRU value is 32
MRU.
no slippage mru The ‘no’ command sets the slippage MRU
to its default, i.e., 32 MRU.
Command (in ICM) Description
service-policy {in|out}
<policy-map name>
This command is entered in the Interface
Configuration mode.
This command is used to attach a policy-
map to an interface.
no service-policy {in|out}
<policy-map name>
This command detaches the policy map
from the interface.