Alcatel-Lucent OmniAccess 5740 - Page 532

Protocol Independent Features
Left running head:
Chapter name (automatic)
506
Beta Beta
OmniAccess 5740 Unified Services Gateway CLI Configuration Guide
Alcatel-Lucent
T
O CONFIGURE STANDARD ACCESS-LIST
EXAMPLE
ALU(config)# access-list 1 deny 1.0.0.0/8
ALU(config)# access-list 2 permit 20.0.0.0/8
T
O CONFIGURE EXTENDED ACCESS-LIST
EXAMPLE
ALU(config)# access-list 101 permit ip 162.168.0.0 0.0.0.0
255.255.252.0 0.0.0.0
Command (in CM) Description
access-list {<1-99>|<1300-
1999>} {deny|permit} {ip-
address [network-number]|ip-
address/prefix-length|any|host
<host-ipaddress>}[log]
This command is used to configure a
Standard Access-list.
Command (in CM) Description
access-list {<100-199>|<2000-
2699>} {deny|permit} {<0-255>
|gre|icmp|ip|ipinip|pim|rsvp|
tcp|udp} {source-ip-address
[network-number]|source-ip-
address/prefix-length|any|host
<source-host-ipaddress>}
{destination-ip-address
[network-number]|destination-
ip-address/prefix-length|
any|host <destination-host-
ipaddress>}[log]
This command is used to configure an
Extended Access-list.