Protocol Independent Features
Left running head:
Chapter name (automatic)
508
Beta Beta
OmniAccess 5740 Unified Services Gateway CLI Configuration Guide
Alcatel-Lucent
T
O CONFIGURE EXTENDED IP ACCESS-LIST RULE
EXAMPLE
ALU(config-ext-nacl)# permit ip 24.0.0.0/8 25.0.0.0/8
ALU(config-ext-nacl)# deny ip any 13.0.0.0/8
Command (in Extended IP Access-list
CM)
Description
{permit|deny}
{igre|icmp|ip|ipinip|pim|rsvp|
tcp|udp|<0-255>} {any|host <host-
ip-address>|<source-ip-address/
prefix-length>|<source-ip-address
subnet-mask>} [operators]
{any|host <host-ip-address>|
<destination-ip-address/prefix-
length>|<destination-ip-address
subnet-mask>} [log] [log-input]
[enable fragment] [precedence
[<0-7>|<keywords>] [tos [<0-
15>|<keywords>]]]
This command is used to configure a
rule for a Extended IP Access-List.
You can configure multiple rules for
an IP access list.
To Next Page
Loading...
