Alcatel-Lucent OmniAccess 5740 - Page 540

Protocol Independent Features
Left running head:
Chapter name (automatic)
514
Beta Beta
OmniAccess 5740 Unified Services Gateway CLI Configuration Guide
Alcatel-Lucent
T
O CONFIGURE ROUTE-MAP SET PARAMETERS
One or more set commands follow a route-map configuration. If there are no set
commands other than the match commands, the matching routes are not altered.
E
XAMPLE
ALU(config-route-map)# set community 10
ALU(config-route-map)# set comm-list 130 delete
ALU(config-route-map)# set dampening 10 2000 2000 15
ALU(config-route-map)# set local-preference 100
ALU(config-route-map)# set weight 10
ALU(config-route-map)# set origin incomplete
Command (in Route-map CM) Description
set community {<1-4294967295>
|AA:NN|additive|local-as|no-
advertise|no-export|none}
Sets the community attribute.
set comm-list {<1-99>|<100-199>}
delete
Removes the communities from the
community attribute of an inbound or
outbound update.
set dampening <1-45> <1-20000>
<1-20000> <1-255>
Sets BGP route dampening factors.
set local-preference <0-
4294967295>
Assigns a local preference to the BGP
path.
set weight <0-4294967295> Use this command to set weight of
route.
BGP has weight attribute. If the same
route is received from multiple routers,
then weight is used to give preference
to some route. Route with highest
weight is preferred.
set origin {igp|egp <1-65535>
|incomplete}
Sets the BGP origin code.
set as-path {tag|prepend [<1-
65535>]}
Modifies the BGP autonomous system
path.
set metric <0-4294967295> Sets the metric value to the
redistributed routes.
This command is normally used in
route-maps for redistribution.
set metric-type {internal|
external|type-1|type-2}
Sets the metric type of the
redistributed routes.