Protocol Independent Features
Except on the first page, right running head:
Heading1 or Heading1NewPage text (automatic)
521
Alcatel-Lucent
Beta Beta
OmniAccess 5740 Unified Services Gateway CLI Configuration Guide
TO CONFIGURE ADMINISTRATIVE DISTANCE
EXAMPLE
ALU(config-router rip)# distance 130 10.0.0.0/8 20
ALU(config-router bgp AS1)#distance 10 100.0.0.0/8 1
ALU(config-router ospf 1)# distance 60 10.0.0.0/8
ALU(config-router ospf 1)# distance ospf external 10
ALU(config-router bgp AS1)#distance bgp 30 10 5
Note: You can also use administrative distance to rate the routing information from routers
running the same routing protocol. This application is generally discouraged if you are
unfamiliar with this particular use of administrative distance as it can result in
inconsistent routing information, including forwarding loops.
Command (in RCM) Description
distance <1-255> [[ip-address
subnet-mask|ip-address/prefix-
length][<1-99>|<1300-1999>]]
This command is used to define an
administrative distance for OSPF or RIP
or BGP.
The default distance for RIP is 120.
The default distance for OSPF is 110.
The default distance is 20 for EBGP
and 200 for IBGP.
distance ospf {external|inter-
area|intra-area} <1-255>}}
This command performs the same
function as the distance command used
with an access list. However, the
distance OSPF command allows you to
set a distance for an entire group of
routes, rather than a specific route that
matches an access-list.
distance bgp <1-255> <1-255>
<1-255>
This command is used to configure
distance for external, internal, and local
routes.
To Next Page
Loading...
