Alcatel-Lucent OmniAccess 5740 - Page 611

OSPF Configuration
Except on the first page, right running head:
Heading1 or Heading1NewPage text (automatic)
585
Alcatel-Lucent
Beta Beta
OmniAccess 5740 Unified Services Gateway CLI Configuration Guide
EXAMPLE
ALU(config-if GigabitEthernet3/0)# ip ospf cost 100
ALU(config-if GigabitEthernet3/0)# ip ospf retransmit-interval
6
ALU(config-if GigabitEthernet3/0)# ip ospf transmit-delay 2
ALU(config-if GigabitEthernet3/0)# ip ospf priority 2
ALU(config-if GigabitEthernet3/0)# ip ospf hello-interval 20
ALU(config-if GigabitEthernet3/0)# ip ospf dead-interval 50
ALU(config-if GigabitEthernet3/0)# ip ospf mtu-ignore
ALU(config-if GigabitEthernet3/0)# ip ospf database-filter all
out
ip ospf mtu-ignore Disables detection of OSPF MTU
mismatch in Database Description
Packets.
By default, MTU mismatch
detection is enabled.
ip ospf database-filter all out Enables filtering of outgoing LSAs on
OSPF interface.
By default, database-filtering is not
enabled.
Command (in ICM) Description