Alcatel-Lucent OmniAccess 5740 - Page 648

Multicast Routing
Left running head:
Chapter name (automatic)
622
Beta Beta
OmniAccess 5740 Unified Services Gateway CLI Configuration Guide
Alcatel-Lucent
T
O CONFIGURE PIM AS BSR
E
XAMPLE
ALU(config)# ip pim bsr-candidate GigabitEthernet3/0 1 10
T
O CONFIGURE RP CANDIDATE PRIORITY
EXAMPLE
ALU(config)# ip pim rp-candidate-priority 10
Command (in CM) Description
ip pim bsr-candidate
{BSRAdminZone prefix/mask
<interface-name>|<interface-
name>} [<0-32>] [<0-255>]
This command is used to configure the
PIM router as BSR candidate. BSR uses
specified interface address.
0-32: Indicates the hash length. This
value is used to select one RP.
0-255: Indicates the priority of the BSR
router.
BSRAdminZone prefix/mask: BSR
Admin Zone can take all multicast
addresses that is greater than 224.0.0.0.
For example, if the Admin Zone is
225.0.0.0/8, all the group addresses
starting with 225 will map to same
Rendezvous Point (RP). This is used for
mapping multiple groups to same RP,
when BSR is used for RP election.
Command (in CM) Description
ip pim rp-candidate-priority
<0-255>
This command is used to configure the
priority of the RP candidate.