Alcatel-Lucent OmniAccess 5740 - Page 688

Virtual Routing and Forwarding
Left running head:
Chapter name (automatic)
662
Beta Beta
OmniAccess 5740 Unified Services Gateway CLI Configuration Guide
Alcatel-Lucent
Step 6: Associate VRF to an interface. See “To Associate a VRF to an Interface”
Note: Associate VRF to an interface prior to IP address configuration as the IP address
configured on the interface is removed when this command is executed.
Step 7: Configure IP address for the interface.
ALU(config-if <interface-name>)# ip address {<ip-
address subnet-mask>|<ip-address/prefix-length>}
Example:
ALU(config-if GigabitEthernet3/0)# ip address
20.20.20.20/24
Step 8: Using Management Utilities in a VRF. See “Using Management Utilities in
a VRF” (Optional)
Step 9: System Monitoring Commands in VRF. See “System Monitoring
Commands in VRF” (Optional)
Step 10: View the VRF-CE configuration. See “VRF Show Commands”