Source NAT Configuration
Except on the first page, right running head:
Heading1 or Heading1NewPage text (automatic)
687
Alcatel-Lucent
Beta Beta
OmniAccess 5740 Unified Services Gateway CLI Configuration Guide
Step 7: Configure IP address for the interface.
ALU(config-if <interface-name>)# ip address {<ip-
address subnet-mask>|<ip-address/prefix-length>}
Example:
ALU(config-if GigabitEthernet3/0)# ip address
20.20.20.20/24
Step 8: Attach the configured SNAT policies to appropriate interfaces as per the
desired direction i.e, either “In/Out”. See “To Attach a NAT Policy to an Interface”
Step 9: Turn On /Turn Off the statistics on an Interface “To Turn On/Off Statistics
on an Interface” (Optional)
Step 10: View NAT configuration. See “NAT Show Commands”.
To Next Page
Loading...
