Alcatel-Lucent OmniAccess 5740 - Page 775

Network Attack Prevention Configuration
Except on the first page, right running head:
Heading1 or Heading1NewPage text (automatic)
749
Alcatel-Lucent
Beta Beta
OmniAccess 5740 Unified Services Gateway CLI Configuration Guide
Step 8: Administratively bring up the interface
ALU(config-if <interface-name>)# no shutdown
Example:
ALU(config-if GigabitEthernet3/0)# no shutdown
Step 9: Configure IP address for the interface
ALU(config-if <interface-name>)# ip address {<ip-
address subnet-mask>|<ip-address/prefix-length>}
Example:
ALU(config-if GigabitEthernet3/0)# ip address
20.20.20.20/24
Step 10: Attach the configured firewall policies to appropriate interfaces as per
the desired direction i.e, either “IN/OUT”. See “To Attach a Firewall Policy to an
Interface”
Step 11: View the firewall configuration. See “Firewall Show Commands”
Step 12: Delete the firewall configuration. See “Firewall Deletion Commands”