Alcatel-Lucent OmniAccess 5740 - Page 869

IPsec VPN Configuration
Except on the first page, right running head:
Heading1 or Heading1NewPage text (automatic)
843
Alcatel-Lucent
Beta Beta
OmniAccess 5740 Unified Services Gateway CLI Configuration Guide
TO CONFIGURE DPD LOCALLY
Note: The default value for DPD time-out is three times that of the DPD interval specified.
E
XAMPLE
ALU(config-crypto-map-map1)# dpd delay 15 timeout 60
ALU(config-crypto-map-map1)# dpd NONE
ALU(config-crypto-map-map1)# no dpd
Note: If there is no global DPD defined, both the dpd none command and no dpd command
produce the same result.
Command (in Crypto Map CM) Description
dpd {interval <5-3600>
[timeout <5-72000>]|none}
This command configures a DPD at the
crypto map mode.
This command allows all connections
associated with a crypto map to use a
DPD policy that is different from the
global policy.
The keyword ‘none’ disables DPD for all
the connections associated with a crypto
map. These connections will not detect
Dead Peer.
The local DPD configuration is given
higher priority than the global DPD
configuration.
no dpd This command removes the local DPD
and switches to the global policy.