IPsec Tunnel Interface Configuration
Except on the first page, right running head:
Heading1 or Heading1NewPage text (automatic)
877
Alcatel-Lucent
Beta Beta
OmniAccess 5740 Unified Services Gateway CLI Configuration Guide
TO ATTACH A TRANSFORM SET TO AN IPSEC PROFILE
Note: If no transform-set is attached to an IPsec profile, ‘default’ transform set is used.
E
XAMPLE
ALU(ipsec-profile-PF1)# transform-set TS1
ALU(ipsec-profile-PF1)# no transform-set
T
O ATTACH PFS GROUP TO AN IPSEC PROFILE
EXAMPLE
ALU(ipsec-profile-PF1)# pfs group2
ALU(ipsec-profile-PF1)# no pfs
Command (in IPsec Profile CM) Description
transform-set <name> This command is used to attach an already
configured transform-set to an IPsec profile.
no transform-set The ‘no’ command detaches the specified
transform-set attached to the profile.
Note: A transform-set must be first
detached from the profile to
delete it globally.
Command (in IPsec Profile CM) Description
pfs {group1|group2|group5} This command is used to attach a PFS
group to an IPsec profile.
Note: If no PFS group is attached to
an IPsec profile, group2 PFS
is used.
no pfs The ‘no’ command disables PFS
completely.
To Next Page
Loading...
