IP Security - Virtual Private Network
Left running head:
Chapter name (automatic)
916
Beta Beta
OmniAccess 5740 Unified Services Gateway CLI Configuration Guide
Alcatel-Lucent
T
O ATTACH A CLIENT PROFILE TO AN INTERFACE
Client profile needs to be applied to an interface through which the IPsec traffic
flows. Binding a client profile to an interface instructs the system to evaluate all
the interface traffic against the crypto client profile, and to use the specified policy
during connection or security association negotiation.
Note: You can attach only one client profile on an interface and vice versa.
E
XAMPLE
ALU(config-if GigabitEthernet3/0)# crypto client profile
myclientprofile
ALU(config-if GigabitEthernet3/0)# no crypto client profile
myclientprofile
Command (in ICM) Description
crypto client profile
<name>
Enter this command in the Interface
Configuration Mode.
This command is used to attach a configured
client profile to an interface.
no crypto client profile
<name>
This command is used to detach a client
profile attached to an interface.
Note: You cannot delete a client profile
that is applied to the interface. To
delete, first detach the client
profile from the interface.
To Next Page
Loading...
