Alcatel-Lucent OmniAccess 5740 - Page 948

Intrusion Detection/Intrusion Prevention System
Left running head:
Chapter name (automatic)
922
Beta Beta
OmniAccess 5740 Unified Services Gateway CLI Configuration Guide
Alcatel-Lucent
Step 7: Enter the Interface Configuration Mode
ALU(config)# interface <name>
Example:
ALU(config)# interface GigabitEthernet3/0
ALU(config-if GigabitEthernet3/0)#
Step 8: Administratively bring up the interface
ALU(config-if <interface-name>)# no shutdown
Example:
ALU(config-if GigabitEthernet3/0)# no shutdown
Step 9: Configure IP address for the interface
ALU(config-if <interface-name>)# ip address {<ip-
address subnet-mask>|<ip-address/prefix-length>}
Example:
ALU(config-if GigabitEthernet3/0)# ip address
20.20.20.20/24
Step 10: Attach the configured firewall policy to appropriate interfaces in the
ingress direction of the interface. See “To Attach a Firewall Policy to an Interface”
Step 11: View the intrusion sensor configuration using show commands. See
“Show Commands”