Burkert FLOWave L - Changing the Address of the Device Connected to a Canopen Bus; Deactivating the Device Internal Termination Resistor

113
General settings – Parameter
Type 8098 FLOWave L
→ Parameter view.
→ büS
→ Advanced
→ Terminationresistor
→ On
→ 
The internal termination resistor is activated.
12.6.4 Deactivating the device internal termination resistor
-
mination resistor.
W
To deactivate the device internal termination resistor, do the following:
→ Go to the CONFIGURATION view.
→ Generalsettings
→ Parameter view.
→ büS Advanced
→ Terminationresistor O
→ 
W termination resistor is deactivated.
12.6.5 Changing the address of the device connected to a CANopen
bus

• If the device is connected to büS, büS automatically addresses the device. By default, the address of the
device on büS is 30.
• 
→ 
address.

same address, do the following to change the address of the device:
→ Go to the CONFIGURATION view.
English