Burkert FLOWave L - Giving a User Defined Name to the Measured Liquid Concentration; Selecting the Liquid Concentration Type; Setting The Parameters Of The Liquid Concentration

180
SAW sensor – Parameter
Type 8098 FLOWave L
15.7 Setting the parameters of the liquid concentration
15.7.1 Giving a user dened name to the measured liquid
concentration

Outputs menu).
By default, the names associated to the measured liquid concentration are Concentration1 and
Concentration2.

→ Go to the CONFIGURATION view.
→ SAWsensor
→ Parameter view.
→ Add.meas.values
→ Concentration1 or Concentration2
→ Valuename .
→   
characters.
→  OK
→ 
The name is changed.
15.7.2 Selecting the liquid concentration type
To select the liquid concentration type, do the following:
→ Go to the CONFIGURATION view.
→ SAWsensor
→ Parameter view.
→ Add.meas.values
→ Concentration1 or Concentration2
→ Concentrationlaw The Currentsettings (liquid and unit) are displayed.
→   
→   
The Newsettings are displayed.
→ 
English