Burkert FLOWave L - Resetting The Default Values Of All The Liquid Density Parameters

201
SAW sensor – Parameter
Type 8098 FLOWave L
15.9.10 Resetting the default values of all the liquid density
parameters
To reset all the default values of all the liquid density parameters, do the following:
→ Go to the CONFIGURATION view.
→ SAWsensor
→ Parameter view.
→ Stand.meas.values
→ Density
→ Resettodefault
→ 
All the liquid density parameters are reset.
→ 
→ 
English