Burkert FLOWave L - Calibrating The K Factor By Using A Teach-In Procedure; Setting The K Factor

264
SAW sensor – Maintenance
Type 8098 FLOWave L
17.7 Setting the K factor


-
brating the K factor by using a teach-in procedure.
To enter the value of the K factor, do the following:
→ Go to the CONFIGURATION view.
→ SAWsensor
→ Parameter view.
→ MAINTENANCE view.
→ Calibration
→ Stand.meas.values
→ Flowrate
→ Kfactor
→ Entervalue
→  
→ 
The new K factor value is used.
17.8 Calibrating the K factor by using a teach-in
procedure

 or 
.


values that are measured by a reference instrument.
The K factor can be:
• .
• 
• automatically calibrated by using a teach-in procedure depending on a known volume.
English