Burkert FLOWave L - Setting The Slope Value Of The Differentiation Factor

274
SAW sensor – Maintenance
Type 8098 FLOWave L
→ Go to the CONFIGURATION view.
→ SAWsensor
→ Parameter view.
→ MAINTENANCE view.
→ Calibration
→ Add.meas.values
→ DF
→ Oset
→ Teach-inbyreference The Currentsettings are displayed.
→ 
→  
The Newsettings are displayed.
→ 


simulation.
→ 
17.16 Setting the slope value of the dierentiation factor
To enter a slope value for the DF, do the following:
→ Go to the CONFIGURATION view.
→ SAWsensor
→ Parameter view.
→ MAINTENANCE view.
→ Calibration
→ Add.meas.values
→ DF
→ Slope
→ Entervalue
English