Burkert FLOWave L - Message An Error Occurred During Communication; Message Max Temperature; Message Max. Flow Rate; Message Totalizer 1 Stopped; Totalizer 2 Stopped Or Mass Totali

330
Maintenance and troubleshooting
Type 8098 FLOWave L
24.9.19 Message "An error occurred during communication"
Message
An error occurred during communication
Symboldisplayedinthe
informationbar
Possiblecause 
Whattodo?
→ 
→ If the cable is damaged, send the device back to Bürkert.
24.9.20 Message "Max. ow rate"
Message

Symboldisplayedinthe
informationbar
(symbol not linked to a user setting)
Possiblecause 

Whattodo?
→ 
24.9.21 Message "Max temperature"
Message

Symboldisplayedinthe
informationbar
(symbol not linked to a user setting)
Possiblecause -
perature is measured in the pipe.
This message does not depend on the liquid temperature limits set by the
user.
Whattodo?
→ 
24.9.22 Message "Totalizer1 stopped"/ "Totalizer2 stopped" or "Mass
totalizer1 stopped"/ "Mass totalizer2 stopped"
Message 
or

Symboldisplayedinthe
informationbar
-
Possiblecause 
Whattodo?
→ / mass totalizer again.
English