Burkert FLOWave L - Configuring a Digital Output as a Frequency Output

295
Outputs – Parameter
Type 8098 FLOWave L

→ Go to the CONFIGURATION view.
→ Outputs
→ Parameter view.
→ Output2:digital or Output3:digital
→ Mode
→ Threshold
→ Settings The Currentsettings are displayed
→ 
→ 
If the high threshold is equal to the low threshold, the digital output is deactivated.
→  
→  
→ 
→   The Newsettings are displayed.
→ 

18.5.3 Conguring a digital output as a frequency output
A frequency output transmits a frequency signal which is proportional to the chosen process value.

→ Go to the CONFIGURATION view.
→ Outputs
→ Parameter view.
→ Output2:digital or Output3:digital
→ Mode
→ Frequency
→ Settings The Currentsettings are displayed
English