Burkert FLOWave L - Resetting The Default Values Of All The Liquid Concentration Parameters; Resetting the Default Values of the Error Limits, the Warning Limits and the Hysteresis of the Liquid Concentration

186
SAW sensor – Parameter
Type 8098 FLOWave L
15.7.9 Resetting the default values of the error limits, the warning limits
and the hysteresis of the liquid concentration
The default values of the error limits, the warning limits and the hysteresis of the liquid concentration are the
following:
• 
• 
• 
• 
• 


→ Go to the CONFIGURATION view.
→ SAWsensor
→ Parameter view.
→ Add.meas.values
→ Concentration1 or Concentration2
→ Limits
→ Resettodefault 
The limit values and the hysteresis value are reset.
→ 
15.7.10 Resetting the default values of all the liquid concentration
parameters
To reset all the default values of the liquid concentration parameters, do the following:
→ Go to the CONFIGURATION view.
→ SAWsensor
→ Parameter view.
→ Add.meas.values
→ Concentration1 or Concentration2
→ Resettodefault
→ 
All parameters of the selected liquid concentration are reset.
→ 
English