Burkert FLOWave L - Activating a User-Defined Damping of the Volume Flow Rate Values

153
SAW sensor – Parameter
Type 8098 FLOWave L
15.4.3 Activating a user-dened damping of the volume ow rate
values

• on the display,
• on the totalizers,
• on the outputs. The damping set for an analog output comes in addition to the damping of the volume

Medium.

→ Low, Medium or High.
→ Or you can set your own damping parameters with the Special damping.
With the Special damping, you can set 2 parameters:
• Responsetime in seconds,
• the Jumpthreshold-
centage, no damping is applied to the second measured value.

→ Go to the CONFIGURATION view.
→ SAWsensor
→ Parameter view.
→ Stand.meas.values
→ Volumeow
→ Damping The Currentsettings are displayed
→ Special
→ Responsetime
→ Jumpthreshold is enabled or disabled
→ Jumpthreshold is enabled, set the value.
→ The Newsettings are displayed 

English