Burkert FLOWave L - Resetting All The Calibration Data To Its Default Values (Standard Measurement Values); Resetting The Offset Of The Liquid Temperature To Its Default Value

272
SAW sensor – Maintenance
Type 8098 FLOWave L
17.12 Resetting the oset of the liquid temperature to its
default value

→ Go to the CONFIGURATION view.
→ SAWsensor
→ Parameter view.
→ MAINTENANCE view.
→ Calibration
→ Stand.meas.values
→ Temperature
→ Resettodefault 

→ 
17.13 Resetting all the calibration data to its default values
(standard measurement values)
The calibration data that can be reset is:
• the K factor,
• 
• 
To reset all the calibration data to its default values, do the following:
→ Go to the CONFIGURATION view.
→ SAWsensor
→ Parameter view.
→ MAINTENANCE view.
→ Calibration
→ Stand.meas.values
→ Resettodefault
→ 
All the calibration data is reset to their default values.
→ 
English