Burkert FLOWave L - Basic Safety Information

9
Basic safety information
Type 8098FLOWaveL
3 BASIC SAFETY INFORMATION
This safety information does not take into account any contingencies or occurrences that may arise during
installation, use and maintenance of the device.

Riskofinjuryduetoelectricalvoltage.
▶ Before carrying out work on the system, disconnect the electrical power for all the conductors and isolate it.
▶ 


▶ Observe all applicable accident protection and safety regulations for electrical equipment.
Riskofinjuryduetopressureintheinstallation.
▶ 
pipe.
▶ Before any intervention in the installation, make sure there is no pressure in the pipe.
▶ 
Ifswitchedonforaprolongedtime,riskofburnsorreduetohotdevicesurfaces
▶ Do not touch with bare hands.
▶ 
Riskofburnsduetohighliquidtemperatures.
▶ Do not touch with bare hands the parts of the device that are in contact with the liquid.
▶ Use safety gloves to handle the device.
▶ Before opening the pipe, stop the circulation of liquid and drain the pipe.
▶ Before opening the pipe, make sure the pipe is completely empty.
Riskofinjuryduetothenatureoftheliquid.
▶ Respect the prevailing regulations on accident prevention and safety relating to the use of dangerous
liquids.
English