Burkert FLOWave L - Message Concentration 1 Too Low; Concentration 2 Too Low; Message Diagnostic Is Active; Message Diagnostic Is Inactive; Messages Due To Diagnostics Events

341
Maintenance and troubleshooting
Type 8098 FLOWave L
24.11.16 Message "Concentration1 too low"/ "Concentration2 too low"
Message

Symboldisplayedinthe
informationbar
Possiblecause The value of the liquid concentration is lower than the permitted minimum

and the hysteresis of the liquid concentration.
Whattodo? As soon as the value of the liquid concentration returns to within the per-
mitted range, the error is automatically reset.
Message 
Symboldisplayedinthe
informationbar
Possiblecause The value of the liquid concentration is lower than the permitted minimum

limits and the hysteresis of the liquid concentration.
Whattodo? As soon as the value of the liquid concentration returns to within the per-
mitted range, the warning is automatically reset.
24.12 Messages due to diagnostics events
24.12.1 Message "Diagnostic is active"
Message
Diagnostic is active
Symboldisplayedinthe
informationbar
Possiblecause 
monitoring special events that occur in the process, on the sensor or on the
electronics.
Whattodo? -
24.12.2 Message "Diagnostic is inactive"
Message
Diagnostic is inactive
Symboldisplayedinthe
informationbar
-
Possiblecause
-
nostics: monitoring special events that occur in the process, on the sensor
or on the electronics.
Whattodo? -
English