Burkert FLOWave L - Configuration Provider Information; Reading out the Current Status of the Configuration Provider

134
General settings – Diagnostics
Type 8098 FLOWave L
→ DIAGNOSTICS view.
→ büSstatus
→ CANopenstatus .
• If the CANopen status is Operational, the PDOs are sent to büS.
• If the CANopen status is Pre-Op (pre-operational), the PDOs are not sent on büS or on the CANopen
Pre-Op status is active if the
Bus mode is set to Standalone).
→ 
13.4 Conguration provider information
13.4.1 Reading out the current status of the conguration provider
Do the following:
→ Go to the CONFIGURATION view.
→ Generalsettings
→ Parameter view.
→ DIAGNOSTICS view.
→ Congurationprovider
→ Status
→ 
 
Status 
Providerstart 
Waitforchanges 
(module).
Initialization 
Waitforclients 
(modules).
Verifyclients 
missing or have been replaced.
Retriggerclients 
when a new client has signed up.
Inactive 
Disabled 
English