Burkert FLOWave L - Changing the Error Limits, the Warning Limits and the Hysteresis of the Liquid Velocity; Resetting the Default Values of the Error Limits, the Warning Limits and the Hysteresis of the Liquid Velocity

192
SAW sensor – Parameter
Type 8098 FLOWave L
15.8.7 Changing the error limits, the warning limits and the hysteresis
of the liquid velocity
To change the error limits, the warning limits and the hysteresis of the liquid velocity, do the following:
→ Go to the CONFIGURATION view.
→ SAWsensor
→ Parameter view.
→ Stand.meas.values Liquidvelocity
→ Limits
→ Settings The Currentsettings are displayed
→  
→  
→  
→  
→   The Newsettings are displayed.
→ 
The limit values and the hysteresis value are changed.
15.8.8 Resetting the default values of the error limits, the warning
limits and the hysteresis of the liquid velocity
The default values of the error limits, the warning limits and the hysteresis of the liquid velocity are the
following:
• 
• 
• 
• 
• 
To reset the default values of the error limits, the warning limits and the hysteresis of the liquid velocity, do
the following:
→ Go to the CONFIGURATION view.
→ SAWsensor
→ Parameter view.
English