Burkert FLOWave L - Resetting All The Parameters Of Each Mass Totalizer To Their Default Values; Resetting The Overflow Counter Of Each Mass Totalizer

215
SAW sensor – Parameter
Type 8098 FLOWave L
15.11.13 Resetting the overow counter of each mass totalizer


→ Go to the CONFIGURATION view.
→ SAWsensor
→ Parameter view.
→ Stand.meas.values
→ Masstotalizer1 or Masstotalizer2
→ Resetoverowcounter
→ 

15.11.14 Resetting all the parameters of each mass totalizer to their
default values
To reset all the parameters of each mass totalizer to their default values, do the following:
→ Go to the CONFIGURATION view.
→ SAWsensor
→ Parameter view.
→ Stand.meas.values
→ Masstotalizer1 or Masstotalizer2
→ Resettodefault 
All the parameters of each mass totalizer are reset to their default values.
→ Go back to the parent menu.
English