Burkert FLOWave L - Connecting the Device to an Ethernet Network (Device Variant with Two 4-Pin M12 Female Connectors - Ethernet Device Variant); Specifications Of The Cables And Conductors For The 4-Pin M12 Female Connectors

70
Electrical installation
Type 8098 FLOWave L
8.17 Specications of the cables and conductors for the
4-pin M12 female connectors
 
Specicationofthecablesandconductors Recommendedvalue
 Shielded conductor with minimum STP
 
 
 
8.18 Connecting the device to an Ethernet network
(device variant with two 4-pin M12 female connectors
– Ethernet device variant)


▶ 

-

with the software Bürkert Communicator.
If a device is connected to an Ethernet network, the measured process values are transmitted via the Eth-
ernet network.
.
1
2
34
• 
• 
• 
• 
 
→ 
clean place.
English