Burkert FLOWave L - Default Settings; Reading Out Some Device Information; Reading out the Ordering Codes of the Device, the Transmitter Board and the Measurement Board; Saw Sensor - Maintenance

257
SAW sensor – Maintenance
Type 8098 FLOWave L
17 SAW SENSOR – MAINTENANCE
17.1 User levels of the editable menu items
SAWsensor – Maintenance menu 
Deviceinformation basic user
Flowdirection Installer
Calibration Installer
Deviceverication Installer
Simulation Installer
17.2 Default settings

country.burkert.com.
→ 
all the default settings of the device.
17.3 Reading out some device information
17.3.1 Reading out the ordering codes of the device, the transmitter
board and the measurement board
To read out the ordering codes of the device, the transmitter board and the measurement board, do the
following:
→ Go to the CONFIGURATION view.
→ SAWsensor
→ Parameter view.
→ MAINTENANCE view.
→ Deviceinformation
→ IDnumbers
→ 
English