Burkert FLOWave L - Resetting The Default Values Of All The Differentiation Factor Parameters; Use Case Example Of The Differentiation Factor

225
SAW sensor – Parameter
Type 8098 FLOWave L
15.12.13 Resetting the default values of all the dierentiation factor
parameters
To reset all the default values of the DF parameters, do the following:
→ Go to the CONFIGURATION view.
→ SAWsensor
→ Parameter view.
→ Add.meas.values DF
→ Resettodefault 
All the DF parameters are reset.
→ 
15.12.14 Use case example of the dierentiation factor

the pipe at a given time.
1
1,3
0,8

 


DF range for liquid 2
DF range for liquid 3
DF
Time
 

→ 
→ 
process value and the process value range associated to an analogue output-
uring a digital output as a frequency output.
→ 
the pipe.
→ .
→ 
English