Burkert FLOWave L - Resetting The Default Values Of All The Liquid Velocity Parameters

193
SAW sensor – Parameter
Type 8098 FLOWave L
→ Stand.meas.values
→ Liquidvelocity
→ Limits
→ Resettodefault
→ 
The limit values and the hysteresis value are reset.
→ 
15.8.9 Resetting the default values of all the liquid velocity
parameters
To reset all the default values of all the liquid velocity parameters, do the following:
→ Go to the CONFIGURATION view.
→ SAWsensor
→ Parameter view.
→ Stand.meas.values
→ Liquidvelocity
→ Resettodefault
→ 
All the liquid velocity parameters are reset.
→ 
→ 
English