Burkert FLOWave L - Deactivating The Monitoring Of The Acoustic Transmission Factor; Resetting the Default Values of the Error Limits, the Warning Limits and the Hysteresis of the Acoustic Transmission Factor

232
SAW sensor – Parameter
Type 8098 FLOWave L
15.13.8 Deactivating the monitoring of the acoustic transmission factor
By default, the acoustic transmission factor values are not monitored.
But if the monitoring of the acoustic transmission factor is active, do the following to deactivate it:
→ Go to the CONFIGURATION view.
→ SAWsensor
→ Parameter view.
→ Add.meas.values
→ Acoustictransmissionfactor
→ Limits
→ Active No.
→ 
The monitoring of the acoustic transmission factor is inactive.
15.13.9 Resetting the default values of the error limits, the warning limits
and the hysteresis of the acoustic transmission factor
The default values of the error limits, the warning limits and the hysteresis of the acoustic transmission
factor are the following:
• 
• 
• 
• 
• 
To reset the default values of the error limits, the warning limits and the hysteresis of the acoustic trans-
mission factor, do the following:
→ Go to the CONFIGURATION view.
→ SAWsensor
→ Parameter view.
→ Add.meas.values
→ Acoustictransmissionfactor
→ Limits
→ Resettodefault 
The limit values and the hysteresis value are reset.
→ 
English