Burkert FLOWave L - Disabling The User To Start, Stop Or Reset Each Mass Totalizer; Starting Each Mass Totalizer; Stopping Each Mass Totalizer

213
SAW sensor – Parameter
Type 8098 FLOWave L
15.11.8 Disabling the user to start, stop or reset each mass totalizer
By default, the user is not allowed to start, to stop or to reset a mass totalizer.
If the Start/Stop/Reset of a mass totalizer is active, do the following to disable them:
→ Go to the CONFIGURATION view.
→ SAWsensor
→ Parameter view.
→ Stand.meas.values
→ Masstotalizer1 or Masstotalizer2
→ Start/Stop/Reset
→ Disabled
→ 
The user is not authorized to start or to stop or to reset a mass totalizer.
15.11.9 Starting each mass totalizer
If the Start/Stop/Reset of a mass totalizer is active, do the following to start the mass totalizer:
→ Go to the CONFIGURATION view.
→ SAWsensor
→ Parameter view.
→ Stand.meas.values
→ Masstotalizer1 or Masstotalizer2
→ Start/Stop
→ Started
→ 
The mass totalizer starts to count.
15.11.10 Stopping each mass totalizer
If the Start/Stop/Reset of a mass totalizer is active, do the following to stop the mass totalizer:
→ Go to the CONFIGURATION view.
→ SAWsensor
→ Parameter view.
English