Burkert FLOWave L - Reading out the Liquid Type and the Liquid Temperature During Calibration at the Manufacturer; Reading out the Raw Measured Value of the Volume Flow Rate

261
SAW sensor – Maintenance
Type 8098 FLOWave L
17.3.7 Reading out the liquid type and the liquid temperature during
calibration at the manufacturer
To read out the type of liquid and the temperature of the liquid used for the calibration of the device at the
manufacturer, do the following:
→ Go to the CONFIGURATION view.
→ SAWsensor
→ Parameter view.
→ MAINTENANCE view.
→ Deviceverication
→ Factorycalibration Medium
→ Factorycalibration Mediumtemperature
→ 
17.3.8 Reading out the raw measured value of the volume ow rate


→ Go to the CONFIGURATION view.
→ SAWsensor
→ Parameter view.
→ MAINTENANCE view.
→ Deviceverication
→ Volumeow Undampedwithoutcut-o
→ 
English