Burkert FLOWave L - Resetting The Flow Rate Calibration Data To Its Default Values; Setting The Offset Value Of The Liquid Temperature

270
SAW sensor – Maintenance
Type 8098 FLOWave L
17.9 Resetting the ow rate calibration data to its default
values

→ Go to the CONFIGURATION view.
→ SAWsensor
→ Parameter view.
→ MAINTENANCE view.
→ Calibration
→ Stand.meas.values
→ Flowrate
→ Resettodefault 

→ 
17.10 Setting the oset value of the liquid temperature
-
.

→ Go to the CONFIGURATION view.
→ SAWsensor
→ Parameter view.
→ MAINTENANCE view.
→ Calibration
→ Stand.meas.values
→ Temperature
→ Oset Entervalue
→  
→ 

English