Burkert FLOWave L - Page 269

269
SAW sensor – Maintenance
Type 8098 FLOWave L
Diameter of the measurement
tube
 Recommended mass, in kg, to get
an accurate K factor
  
  
DN40  
  
  
DN80  
→ 
→ Go to the CONFIGURATION view.
→ SAWsensor
→ Parameter view.
→ MAINTENANCE view.
→ Calibration
→ Stand.meas.values
→ Flowrate
→ Kfactor
→ Teach-inbymass The current K factor is displayed.
→ 

→ 
→   The Newsettings are displayed.
→ 
The new K factor is used.


simulation.
→ 
English