Burkert FLOWave L - Setting The Slope Value Of The Acoustic Transmission Factor

281
SAW sensor – Maintenance
Type 8098 FLOWave L
17.25 Setting the slope value of the acoustic transmission
factor
To enter a slope value for the acoustic transmission factor, do the following:
→ Go to the CONFIGURATION view.
→ SAWsensor
→ Parameter view.
→ MAINTENANCE view.
→ Calibration
→ Add.meas.values
→ Acoustictransmissionfactor
→ Slope
→ Entervalue
→  
→ 
The slope value of the acoustic transmission factor is set.
English