Burkert FLOWave L - Changing The Preset Value For A Mass Totalizer Reset; Resetting each Mass Totalizer to a Preset Value

214
SAW sensor – Parameter
Type 8098 FLOWave L
→ Stand.meas.values Masstotalizer1 or Masstotalizer2
→ Start/Stop
→ Stopped
→ 
The mass totalizer stops counting.
15.11.11 Resetting each mass totalizer to a Presetvalue
If the Start/Stop/Reset of a mass totalizer is active, do the following to reset the mass totalizer to the Preset
value:
→ Go to the CONFIGURATION view.
→ SAWsensor
→ Parameter view.
→ Stand.meas.values
→ Masstotalizer1 or Masstotalizer2
→ Valuereset
→ 
The mass totalizer is reset to the preset value.
→ 
mass totalizer reset.
15.11.12 Changing the Presetvalue for a mass totalizer reset
The default value of the Presetvalue is 0.0 l.
If the Start/Stop/Reset of a mass totalizer is active, do the following to change the preset value:
→ Go to the CONFIGURATION view.
→ SAWsensor
→ Parameter view.
→ Stand.meas.values
→ Masstotalizer1 or Masstotalizer2
→ Presetvalue
→  
→ 
The value is changed.
English