Burkert FLOWave L - Resetting All The Parameters Of All The Outputs To Their Default Values; Resetting All The Parameters Of An Output To Their Default Values

298
Outputs – Parameter
Type 8098 FLOWave L
18.6 Resetting all the parameters of an output to their
default values
To reset all the parameters of an output to their default values, do the following:
→ Go to the CONFIGURATION view.
→ Outputs
→ Parameter view.
→ 
→ Resettodefault
→  All the parameters of the output are reset.
→ 
18.7 Resetting all the parameters of all the outputs to their
default values
To reset all the parameters of all the outputs to their default values, do the following:
→ Go to the CONFIGURATION view.
→ Outputs
→ Parameter view.
→ Resettodefault
→  The parameters of all the outputs are reset.
→ 
English