Burkert FLOWave L - Resetting The Device; Resetting the Device to All Its Factory Settings; Restarting the Device

142
General settings – Maintenance
Type 8098 FLOWave L
14.3 Resetting the device
WARNING
Riskofinjuryduetonon-conformingadjustment.
Non-conforming adjustment could lead to injuries and damage the device and its surroundings.
▶ The operators in charge of adjustment must have read and understood the contents of the Operating
Instructions.
▶ In particular, observe the safety recommendations and intended use.
▶ 
14.3.1 Restarting the device
To restart the device, do the following:
→ Go to the CONFIGURATION view.
→ Generalsettings
→ Parameter view.
→ MAINTENANCE view.
→ Resetdevice
→ Restart
The device restarts.
14.3.2 Resetting the device to all its factory settings
To reset the device to all its factory settings, do the following:
→ Go to the CONFIGURATION view.
→ Generalsettings
→ Parameter view.
→ MAINTENANCE view.
→ Resetdevice
→ Resettofactorysettings to reset the device to all its factory settings.
The device is reset to all its factory settings.
→ Acknowledge the displayed message.
English