Burkert FLOWave L - Deactivating The Damping Of The Differentiation Factor Values

219
SAW sensor – Parameter
Type 8098 FLOWave L
→ DF
→ Damping The Currentsettings are displayed
→ Special
→ Responsetime
→ Jumpthreshold is enabled or disabled
→ Jumpthreshold is enabled, set the value.
→ The Newsettings are displayed 
The special damping of the DF values is active.
15.12.5 Deactivating the damping of the dierentiation factor values
If the damping of the DF values is active, do the following to deactivate it:
→ Go to the CONFIGURATION view.
→ SAWsensor
→ Parameter view.
→ Add.meas.values
→ DF .
→ Damping The Currentsettings are displayed
→ None The Newsettings are displayed.
→ 
The damping of the DF values is inactive.
English