321
Maintenance and troubleshooting
Type 8098 FLOWave L
24.2 Information on returning the device to the
manufacturer or to the reseller
→ To return the device for calibration or any after sales service, use the original packaging.
→
are available on the internet at country.burkert.com.
24.3 Cleaning the outer surface of the device
• Always use a cleaning agent compatible with the materials from which the device is made.
• Pay special attention to the cable glands which are made of nickel plated brass.
The outer surface device can be cleaned with a cloth slightly dampened water or with a detergent com-
patible with the materials the device is made of.
Please feel free to contact your Bürkert supplier for any additional information.
24.4 Cleaning In Place (CIP) of the device
The measurement tube of the device can be cleaned in place in all the applications the device is used in.
→ Do the cleaning in place procedure at appropriate intervals to prevent malfunctions or contamination.
NOTICE
Thedeviceandthesealsusedontheprocessconnectionscanbedamagedbythecleaningagentsor
thedisinfectingagents.
▶ Use cleaning agents or disinfecting agents with a concentration that is compatible with the material the
measurement tube is made of.
▶ Check the chemical compatibility of the cleaning agents or disinfecting agents with the materials of the
seals used on the process connections.
▶ For more information on the chemical compatibility and the cleaning temperatures contact your local
▶ Obey the cleaning in place procedure that is suited for your application.
Procedure for the cleaning in place of the device:
→ Rinse the measurement tube with water of the best quality available in the factory (ideally, water for
for a duration that is determined by your CIP recipe.
→ Prepare one or two cleaning agents at concentrations and with chemical properties that have proven
→
for a duration that is determined by your CIP recipe.
English
To Next Page
Loading...
