202
SAW sensor – Parameter
Type 8098 FLOWave L
15.10 Setting the parameters of the volume totalizers
15.10.1 Giving a user dened name to each volume totalizer
Outputs menu).
By default, the names associated to the volume totalizers are Totalizer1 and Totalizer2.
→ Go to the CONFIGURATION view.
→ SAWsensor
→ Parameter view.
→ Stand.meas.values
→ Totalizer1 or Totalizer2
→ Valuename .
→
characters.
→ OK
→
The name is changed.
15.10.2 Choosing the counting direction of each volume totalizer
By default, the counting direction of both volume totalizers is Positiveonly.
The possible counting directions are:
• Positiveonly
positive, i.e. in the same direction as the arrow located on the front of the device.
• Negativeonly
negative, i.e. in the direction opposite to the direction of the arrow located on the front of the device.
• Both
To change the counting direction of each volume totalizer, do the following:
→ Go to the CONFIGURATION view.
→ SAWsensor
→ Parameter view.
→ Stand.meas.values Totalizer1 or Totalizer2
English
To Next Page
Loading...
